Our heat pump installation areas around Whangarei
Your local installer covers greater Whangarei, from the city suburbs out to the harbour and the Bream Bay coast. Tell us where you are and we'll sort a quote.
Heat pumps are installed right across greater Whangarei, from Kamo, Tikipunga, Maunu and Onerahi through to Parua Bay on the harbour and Ruakaka, One Tree Point and Waipu down on Bream Bay. If you're in or near town, your local installer will come out and quote it.
The four areas we cover
Greater Whangarei is not one situation, it is four. The housing stock, how the damp behaves and how much salt is in the air all change markedly between the inner city, the northern valleys, the harbour edge and the Bream Bay coast, and so does the unit that suits. Find yours below.
Whangarei city
Kauri villas through Kensington and the Avenues, and street after street of post-war weatherboard in Morningside, Woodhill and Otaika. High studs, single glazing and no wall insulation, so sizing is done on volume rather than floor area. Hill suburbs run drier and windier than the river flats.
Covers: Kensington, Riverside, Maunu, Whau Valley, Morningside, Woodhill, Avenues, Sherwood Rise, Horahora, Vinetown, Raumanga and Otaika.
Kamo & the north
Inland and lower than the rest of the district, so cold air settles overnight and the fog sits until mid-morning. Damp is the problem here rather than raw cold, and the unit is sized to hold a low steady output that dries the house out. Far enough from the sea that a standard-coated unit is fine.
Covers: Kamo, Tikipunga, Regent and Hikurangi.
Onerahi & the harbour
Right on the harbour, where salt is the thing that decides how long a heat pump lasts. Corrosion-resistant outdoor units, stainless brackets, and a position on the landward side rather than the wall facing the water. A rinse with fresh water every few months does the rest.
Covers: Onerahi and Parua Bay.
Bream Bay coast
Newer, bigger and more open-plan than town, and fully exposed to the open ocean. One high-wall unit rarely does a modern open-plan living area, so ducted and multi-split systems come into their own. About thirty kilometres out, so the job gets planned properly up front.
Covers: Ruakaka, Waipu, One Tree Point and Marsden Point.
Not sure which group you are in, or somewhere not listed? Ring 09 242 6071 and ask, or send your details through for a free quote. It helps to know how the job runs, what it is likely to cost, and what ongoing servicing involves.
Not sure if we reach your street?
Give us a call on 09 242 6071 or flick through your address. If you're anywhere in greater Whangarei, chances are your local installer can help.
Questions about the areas covered
What areas do you install heat pumps in around Whangarei?
Heat pumps are installed across greater Whangarei, from the city suburbs like Kamo, Tikipunga, Maunu and Onerahi out to Parua Bay on the harbour and down the Bream Bay coast. If you're in or close to town, your local installer will come out and quote the job. Not sure if you're in range? Just give us a call and ask.
Do you install heat pumps in Ruakaka and One Tree Point?
Yes, both. Ruakaka and One Tree Point are a regular part of the patch covered, along with Waipu further down the coast. A lot of homes there are newer open-plan builds near the water, so extra care is taken siting the outdoor unit away from the salt-laden sea breeze to make it last.
Tell us where you are
From Kamo to Waipu, drop us your suburb and what you want heated and your local installer will get you a fixed quote. Call 09 242 6071 or send it through online.